MXY255-125 Busduct Pressing Clamping Machine processing machine
Use and requirements:The busbar press is equipped with three parts:
riveting table, prefabricated table and discharge table. It is used for
riveting assembly of busbar row of 91 ~ 255mm width and height of 125mm.
After the busbar row is installed, push the riveting table and press
Will be targeted after the compression to facilitate the artificial
With relay control, pneumatic clamping, no power roller with integral
installation, roller surface covered with polyurethane, to prevent
scratching the bridge. The frame steel beam is formed by bending the
steel plate and is supported by the steel pipe of the square pipe, which
can be adjusted according to the need, the rack surface spray (gray).
The upper pressing device is made of bolts with 8mm steel plate as a
whole and guided by guide block. Work will be pre-installed bridge to
the appropriate position, depress the foot switch, the top material
device to lift the bridge from the roller in place after the remain
intact, both sides of the clamping device action clamping the bridge,
the last pressure Tight device action will be copper compacted. After
the completion of artificial riveting, step down the foot switch, the
pressure on the rise, both sides of the pressure release, the top
material device down the bridge to fall back to the roller surface, the
bridge pushed out to the discharge station for follow-up operation.
Bridge processing requirements:
1, the bus press for 125 × 255 and 125X91 between the specifications of the bridge, before the riveting clamping operation.
2, Pre-installed part of the pneumatic block on the device.
Busbar press machine instructions:
Including safety warning, machine principle, performance parameters,
pneumatic schematic diagram, accessory table, wiring table, safe
2 sets of the foot switch , 1 sets of attachment tool , instruction, 1 set of the certificate ,Packing List.